BRRD-8-074LS Michelangelo Medallion View larger

BRRD-8-074LS Michelangelo Medallion

BRRD-8-074LS

New product

BRRD-8-074LS Michelangelo Medallion

31½" Width  31½" Length  2916" Depth

Diameter: 31 1/2"

More details

$437.50

Data sheet

Height31 1/2 inches
Width31 1/2 inches
Depth2 9/16 inches

More info

Michelangelo Ornate Medallions

Our Michelangelo Series of medallions come completely finished and ready to install on your ceiling. The medallions project 3-4" out from the ceiling so they provide another element of depth to the room. They are built from fiberglass, pvc, and other high-impact materials and come ready with a hole in the center for your lighting fixture. If you are not installing a lighting fixture with the medallion then you can still use these by ordering a small rosette to cover the medallion's center hole. 

The ceiling medallions are flat on the back so they can be installed on any flat ceiling or wall. They are delivered fully assembled so they are easy to install. Since these are large medallions be sure to have at least 2 people involved with the installation.

Installation Instructions

Materials & Tools

  • Screw Gun / 2” Sheet Rock Screws
  • Adhesive / Caulking Gun
  • Tape Measure / Pencil
  • Caulking (paintable latex)
  • Utility Knife

Step 1 - Getting Started
If you are installing the medallion with a ceiling fan, chandelier or light, make sure the power is shut off at the breaker before attempting installation. Turning off the light switch WILL NOT prevent you from being shocked. If you have any doubts call an electrician.

Medallions are for decorative purposes only and cannot support the weight of a fan or light fixture. Your fixture must be supported by a support or junction box in the ceiling.

Step 2 - Aligning the Medallion
Using your center point or fixture as a reference, lightly mark the ceiling with pencil where the perimeter of the medallion will be.

Step 3 - Adhesive
Adhesive should be applied liberally to the backside of the medallion where it touches the ceiling. Sheet rock screws will secure the medallion while the adhesive sets. You can use any adhesive that is rated for use with wood (check the back of the label) -- we have found that using Liquid Nails™ works well and is available at most home improvement stores.

Step 4 - Installation
Consult your fixture’s instructions. You may need to purchase additional hardware to make your fixture compatible with the offset of the medallion.

Before beginning, be sure to have several people available to lift and hold the medallion in place while you secure the medallion to the ceiling. With the medallion on the ground, apply adhesive liberally to the backside where it will touch the ceiling. Lift the medallion up near the ceiling and feed the electrical wires through the center of the medallion. Once the wiring is through, press the medallion against the ceiling and make sure it is properly aligned.

While your helpers continue to hold the medallion in place, use 2” sheet rock screws around the perimeter to secure it to the ceiling. On round models there will usually be exposed holes for you to screw through.

On rectangular models screw in between the teeth on the dentil section that borders the medallion. You can later cover the screws with the supplied caps for round medallions, or touch up the screw heads with the gold paint provided for rectangular medallions.

Reviews

No customer reviews for the moment.

Write a review

BRRD-8-074LS Michelangelo Medallion

BRRD-8-074LS Michelangelo Medallion

BRRD-8-074LS Michelangelo Medallion

31½" Width  31½" Length  2916" Depth

Diameter: 31 1/2"